Lexmark 3455 User Manual download pdf (Page 89)

7.4 Configuring a MarkNet XLe External Print

Server

To enable IPDS printing with the MarkNet XLe several settings must be changed.

Changes to MarkNet XLe settings can only be made using the appropriate network

printer utilities. For more information on how to change these settings, refer to your

Lexmark network adapter manual, which came with your print server.

Network Adapter User's Guide or

Network Adapter Hardware Setup or

MarkNet XLe Setup and Service Guide

7.4.1 Printing a MarkNet XLe Setup Page

Microcode Level

MarkNet XLe 04.130.01 (or greater)

To see the code level, you need to print the setup page. Under the section Network

Card, look for Firmware Revision. The middle number (in this case “130”) is the one

you want to be greater than or equal to.

To print the MarkNet XLe setup page, do the following:

1. Remove the adapter’s switch cover.

2. Press the Test button until the Test light comes on. The XLe setup page will

print on the attached printer.

3. Replace the adapter’s switch cover.

For more information, see Lexmark’s Network Printer Utility Guide.

If you need to update your MarkNet XLe code level, contact the Lexmark Technical

Support Center. MarkNet XLe firmware updates are also available from the Lexmark

web site at http://www.lexmark.com.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 180 181

No comments

Lexmark 3455 User Manual Page 89