Lexmark XC2132 User's Guide download pdf (Page 37)

Use the To

1 USB wireless port Attach an optional wireless network adapter.

2 Security lock port Lock the controller board.

3 Printer power cord

socket

Connect the printer to a properly grounded electrical outlet.

4 LINE port Connect the printer to an active telephone line through a standard wall jack (RJ‑11), DSL

filter, or VoIP adapter, or any other adapter that allows you to access the telephone line

to send and receive faxes.

5 EXT port Connect additional devices (telephone or answering machine) to the printer and the

telephone line. Use this port if you do not have a dedicated fax line for the printer and if

this connection method is supported in your country or region.

Note: Remove the adapter plug to access the port.

6 Rear USB port Attach a keyboard.

7 USB printer port Connect the printer to a computer using a USB cable.

8 Ethernet port Connect the printer to an Ethernet network.

Networking

Notes:

• Purchase a MarkNet

N8352 wireless network adapter before setting up the printer on a wireless network. For

information on installing the wireless network adapter, see the instruction sheet that came with the adapter.

• A Service Set Identifier (SSID) is a name assigned to a wireless network. Wired Equivalent Privacy (WEP), Wi-Fi

Protected Access (WPA), WPA2, and 802.1X - RADIUS are types of security used on a network.

Preparing to set up the printer on an Ethernet network

To configure your printer to connect to an Ethernet network, organize the following information before you begin:

Note: If your network automatically assigns IP addresses to computers and printers, continue on to installing the

printer.

• A valid, unique IP address for the printer to use on the network

• The network gateway

• The network mask

• A nickname for the printer (optional)

Note: A printer nickname can make it easier for you to identify your printer on the network. You can choose to

use the default printer nickname, or assign a name that is easier for you to remember.

You will need an Ethernet cable to connect the printer to the network and an available port where the printer can

physically connect to the network. Use a new network cable when possible to avoid potential problems caused by a

damaged cable.

Additional printer setup 37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 340 341

No comments

Lexmark XC2132 User's Guide Page 37