Lexmark 11N1522 Datasheet Page 119

  • Download
  • Add to my manuals
  • Print
  • Page
    / 171
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 118
To change the redial settings:
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Dialing and Sending appears.
6 Press .
7 To change the number of times the printer will redial:
a Press or repeatedly until Redial Attempts appears.
b Press .
c Press or repeatedly until the setting you want appears.
d Press .
8 To change the length of time between redials:
a Press or repeatedly until Redial Time appears.
b Press .
c Press or repeatedly until the setting you want appears.
d Press .
Schedule to resend fax at a later time
See “Sending a broadcast fax at a scheduled time” on page 42.
Phone Line Error
These are possible causes and solutions. Try one or more of the following:
Review digital phone service checklist
The fax modem is an analog device. Certain devices can be connected to the printer so that digital telephone services
can be used.
If you are using an ISDN telephone service, connect the printer to an analog telephone port (an R-interface port)
on an ISDN terminal adapter. For more information and to request an R-interface port, contact your ISDN
provider.
If you are using DSL, connect to a DSL filter or router that will support analog use. For more information, contact
your DSL provider.
If you are using a PBX telephone service, make sure you are connecting to an analog connection on the PBX.
If none exists, consider installing an analog telephone line for the fax machine. For more information on faxing
when using a PBX telephone service, see “Setting up to fax while behind a PBX” on page 61.
Check phone line
If the telephone line is being used by another device, wait until the other device is finished before sending the fax.
119
Page view 118
1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 170 171

Comments to this Manuals

No comments