Lexmark 11N1522 Datasheet Page 115

  • Download
  • Add to my manuals
  • Print
  • Page
    / 171
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 114
7 Press or repeatedly until Dial Prefix appears.
8 Press .
9 To change the setting, press or repeatedly until Create appears.
10 Press .
11 Enter the prefix to be dialed before each telephone number.
12 Press .
Check Speed Dial number
Check to make sure Speed Dial has been programmed for the number that you want to dial. See “Setting up
Speed Dial” on page 61.
As an alternative, dial the telephone number manually.
Be sure the printer is detecting a dial tone
See “Sending a fax while listening to a call (On Hook Dial) using the control panel” on page 41.
Check the Dial Method setting.
1 Listen for a dial tone. If you hear a dial tone but the printer hangs up without dialing, this means it did not
recognize the dial tone.
2 From the control panel, press Fax Mode.
3 Press .
4 Press or repeatedly until Fax Setup appears.
5 Press .
6 Press or repeatedly until Dialing and Sending appears.
7 Press .
8 Press or repeatedly until Dial Method appears.
9 Press .
10 Press or repeatedly until Behind PBX appears.
11 Press to save this setting.
Printer receives a blank fax
These are possible causes and solutions. Try one or more of the following:
Check original document
Ask the sender to verify the original document was loaded correctly.
Check ink
Check the ink levels, and install a new print cartridge if necessary.
115
Page view 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 170 171

Comments to this Manuals

No comments