Lexmark C 910 User Manual download pdf (Page 76)

Configure for TCP/IP

Step 9: Configure for TCP/IPP/IP

If you have TCP/IP available on your network, we recommend that

you assign an IP address to the printer.

Setting the printer

IP address

If your network is using DHCP, an IP address is automatically

assigned after you connect the network cable to the printer.

1 Look for the address under the TCP/IP heading on the network

setup page you printed in “Printing a network setup page” on

page 69.

2 Go to “Verifying the IP settings” on page 71 and begin with

step 2.

Note: You can find instructions

for other methods of setting the

IP address in the online

documentation on the

drivers CD that shipped with

your printer. Launch the CD,

click View Documentation, and

then click Network Printer

Install.

If your network is not using DHCP, you must manually assign an IP

address to the printer. One of the easiest ways is to use the operator

panel:

1 Press Menu until you see Network Menu, and then press

Select.

2 Press Menu until you see Standard Network, and then press

Select.

Standard Network appears if you purchased a printer with a

network port on the printer system board. If you have an

optional MarkNet card installed, you see Network Option 1.

3 Press Menu until you see Std Net Setup or Network 1 Setup,

and then press Select.

4 Press Menu until you see TCP/IP, and then press Select.

5 Press Menu until you see Set IP Address, and then press

Select.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 91 92

No comments

Lexmark C 910 User Manual Page 76