Lexmark 436 User Manual download pdf (Page 93)

5 In the Network Time Protocol section, select Enable NTP.

Note: If you prefer to set the date and time manually, click inside the Manually Set Date & Time box, and then

enter the current date and time.

6 Verify that the time zone is correct.

7 Click Submit.

Turning daylight saving time on or off

The printer can be set to automatically adjust for daylight saving time for certain time zones:

1 Type the printer IP address into the address field of your Web browser.

Note: If you do not know the IP address of the printer, then print a network setup page and locate the address

in the TCP/IP section.

2 Click Settings.

3 Click Security.

4 Click Set Date and Time.

5 Select Automatically Observe DST.

6 Click Submit.

Sending a fax

Sending a fax using the printer control panel

1 Load an original document faceup, short edge first into the ADF or facedown on the scanner glass.

Note: Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine

clippings) into the ADF. Place these items on the scanner glass.

2 If you are loading a document into the ADF, then adjust the paper guides.

3 From the printer control panel, press the Fax button.

4 Enter the fax number, and then press .

Notes:

• To cause a two‑ or three‑second pause in a fax number, press the Redial/Pause button. The dial pause

appears as a comma on the “Fax to” line. Use this feature if you need to dial an outside line first.

• Press to move the cursor to the left and delete a number.

• To use a fax shortcut, press , and then press the arrow buttons until the fax shortcut you want appears.

Press

5 Press 1 to enter another fax number, or press 2 to end fax number entry.

6 Press .

Faxing 93

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 234 235

No comments

Lexmark 436 User Manual Page 93